What is sweep command in Rhino?
The Sweep1 command fits a surface through a series of profile curves that define the surface cross-sections and one curve that defines a surface edge. Select cross-section curves in the order that the surface will pass through them. Note. ● Select open curves near the same ends.
Which is the proper order for creating a sweep with a guide curve?
To create a sweep:
- Sketch a closed, non-intersecting profile on a plane or a face. If you use guide curves:
- Create the path for the profile to follow. Use a sketch, existing model edges, or curves.
- Click one of the following:
- In the PropertyManager:
- Set the other PropertyManager options.
- Click OK.
What is sweep surface?
Sweep Surfaces are surfaces that are generated from a section curve positioned along a path. Sweep by Two Guide Curves is defined as moving and adjusting a section curve along two guide curves.
What is loft in rhino?
The Loft command fits a surface through selected profile curves that define the surface shape. Select the curves in the order in which the surface should pass through them. Continue to adjust the seam points until they line with each other and the closed curves all have the same direction, and then press Enter.
What does revolve do in Rhino?
Creating revolved surfaces – Rhino for Mac Tutorial Revolve creates a Surface by rotating a profile curve around an axis. If you’ve ever made something on a lathe or a pottery wheel, you’ll probably feel right at home using Revolve.